#New_article

Stay tuned, our new article has been accepted and just published in the Journal of Polymer Engineering and Science.

"A comparative in-process monitoring of temperature profile in fused filament fabrication"

Two different approaches in parallel, local and global temperature profile, have been applied.

It was shown that there is a remarkable difference between the cooling rate and re-heating peaks. The primary out-come of this study is the consideration of results accuracy and the possibility of working on optimization of the obtained temperature profile. Altogether it helps optimize inter-layer strength while assessing the temperature evolution.

https://doi.org/10.1002/pen.25555

#newarticle #additivemanufacturing #3dprinting #engineering